Categories
BLOG

pax 2 directions

Quick Guide to using your Pax 2

Hey! You’re probably on this page because you made the great decision to purchase a Pax 2; a great looking smart vaporizer.

We wanted to ensure that you have the best possible experience so we created this brief guide on how to to get the most out of your Pax 2,

You will have the following pieces included in the box:

  • Pax 2 device
  • Raised mouthpiece
  • Magnetic oven lid
  • Magnetic Charger
  • 10x Cleaning tools

Charging your Pax 2

The Pax 2 has a unique magnetic charging dock – it snaps right into place as soon as you place the charger near the port on the back of the device.#

You’ll know when your pax has reached a full charge when all four LEDs are light – it should take roughly two hours.

Perform a quick burnoff of the Pax 2’s oven.

Once the battery is fully charged, it is worth performing a quick ‘burn-off’ of the Pax’s oven. Occasionally residue from the manufacturing process can be left in your vaporizer’s oven. This can affect the taste of your first session.

To carry this out, power on the Pax by pressing the power button in the centre of the mouthpiece once.

Leave the Pax 2 oven on for five minutes. Repeat this process once more to complete the burn off process.

Packing your Pax 2

Now our Pax 2 is charged and the burn off is complete, we’re ready to get started!

Remove the magnetic oven cover at the bottom of the Pax. Before placing any herb in the oven, first, ensure you have ground your herbs as finely as possible.

The Pax performs best when your herbs are packed firmly and the oven is at least half full.

Choose your mouthpiece

The Pax 2 can be used with either the flat mouthpiece that is fitted into the device or this can be swapped out for the raised mouthpiece.

The flat mouthpiece is great because it is really discreet however, some prefer the natural feel of the raised mouthpiece.

Powering on your Pax 2

To turn the Pax 2 on, press the power button in the centre of the mouthpiece once – the vaporizer should immediately begin to heat up.

Whilst heating up the LEDs will pulsate with a soft purple colour and turn green when it has reached the set temperature.

Changing the temperature settings of your Pax 2

The Pax 2 has four temperature setting. To adjust the temperature you have to put your Pax into temperature mode.

To do this, when the Pax 2 in turn on, hold the power button until the LEDs turn yellow.

Now you can cycle through the four settings by pressing the power button once. Each LED corresponds to a temperature setting with 1 LED being the coolest temperature and 4 being the hottest.

To set your chosen temperature, hold the power button for an extended period again until the LEDs turn from yellow to purple or green.

Further Reading

  • Tips for getting the most out of your brand new dry herb vaporizer.
  • How to best clean your vaporizer.
  • Choosing the right temperature for your dry herb vaporizer.

We are sure you’ll enjoy your Pax 2!

If you have any questions, please contact us.

Quick Guide to using your Pax 2 Hey! You're probably on this page because you made the great decision to purchase a Pax 2; a great looking smart vaporizer. We wanted to ensure that you have the best possible experience so we created this brief guide on how to to get the most out of your Pax 2, You will have the follo

Pax 2 User Guide: 5 Tips for Pax Vaporizer

2018-02-28 23:20:50

Ever since the Pax 2 came out in 2015, it has been one of the most popular choices among vapers everywhere. It has yet to lose its appeal and is still a well-loved, frequently used vaporizer choice. If you’re thinking about getting a Pax 2 or have just unboxed yours for the first time and are ready to learn something simple like how to turn Pax 2 off or just how to use it in general, check out the Pax 2 tips in this Pax 2 user guide.

Charging the Pax 2

With your Pax 2, you’ll get a charging cradle that will be used to power your vape. To charge it, place the Pax 2 on this charging cradle, being sure to connect the two ports found on the back of the vape to the two prongs that can be found on the charging dock. Be sure that the Pax 2 charging cable is plugged into the power source completely and then again into the charging dock itself.

The LED petals on the Pax 2 will light up depending on how much charge it has. When the vaporizer is charging and the battery is anywhere between zero and 24 percent charged, all of these little petals will flash on and off. When the battery hits 25 percent to 49 percent charged, the top left petal will be a solid glow. Between 50 percent and 74 percent of being charged, the top two petals will then turn solid. Between 75 percent to 99 percent, three of the petals will glow solid. When the Pax 2 is finally charged, all of the petals will be solid.

Typically, this process takes around two or three hours to complete. This depends on the power outlet; for instance, using a wall outlet is going to charge this dry herb vaporizer more quickly than charging it on a car charger or computer.

Loading the Pax 2

Before vaping, you need to know how to pack a vaporizer, such as the Pax 2. First, just remove the lid by pressing down on one side of it and let it pop out. Be sure to grind down the herb in an ultra-fine manner and pack it tightly for best results. Use a high-quality grinder to achieve the right consistency. Once it’s packed, tamp it down using any loading tool. Then, put the oven lid back on. Be sure that the Pax 2 chamber has been cooled off before you take off the oven lid, as it can burn your fingers when it’s hot; it should be cool in only a few minutes after turning it off.

When you do load it, be sure that you have overfilled the chamber slightly so you can pack it down nice and tight. The herb should sit flush with the brim of the oven. This provides you with even smoother and more efficient hits. It is recommended that you load anywhere between .15 grams and .35 grans at a time.

Changing Temperatures

To switch the temperature, just press the button in the center of the Pax 2 and hold it down to access the temperature control mode. Then, press down on this button quickly to cycle through the four available temperatures. Once you have selected the vaporizer temperature you want, hold that same button down in order to secure your choice. The temps will be displayed using the lights on the four petals. They are as follows:

– One petal means the temperature is set at 360 degrees Fahrenheit.
– Two petals means the temperature is set at 380 degrees Fahrenheit.
– Three petals means the temperature is set at 400 degrees Fahrenheit.
– Four petals means the temperature is set at 420 degrees Fahrenheit.

Best Hitting Methods

You can hit the Pax 2 in two different ways: rips or sip. Sipping is the method of taking tiny little draws from the vape as if you were sipping tea. Usually, a sip draw will last between two and four seconds. Those who rip it take much large hits and, in turn, get more herbal vapor. You can choose to rip or sip the Pax 2 depending on your preference. Some people start by sipping and then rip it as the session goes on to ensure the vapor production is consistent.

Cleaning and Maintenance

If you want your Pax 2 to last for as long as possible, it is imperative that you take care of it. The first part of that is knowing when to clean it. When you start to see buildup in the Pax 2 screen, mouthpiece, chamber or vapor tube, you will know that it’s time. You will also notice that it is time to clean when the hits become weaker, less flavorful or less efficient. It is recommended to keep cleaning your vaporizer at least once a month.

To clean, you will need a few tools such as isopropyl alcohol and cotton swabs. You will want to start by soaking the screen and the mouthpiece in the alcohol and, while the mouthpiece is soaking, you will want to dip a cotton swab into alcohol and gently swab down the chamber. Thoroughly remove any buildup, and run a pipe cleaner through the vapor path to floss it out.

In this Pax 2 review of how to use and maintain your vape, we’ve made it simple for you to understand how to charge, pack, use and clean your favorite vaporizer. We hope this guide makes using this impressive vaporizer even more pleasurable than it already is. Return to this page if you have any questions down the line, and happy vaping!

Pax 2 User Guide: 5 Tips for Pax Vaporizer 2018-02-28 23:20:50 Ever since the Pax 2 came out in 2015, it has been one of the most popular choices among vapers everywhere. It has yet to lose ]]>